3. SETUP GUIDE
RF-Link
1. Connect transmitter antenna to APW-1000 (via "RF OUT).
2. Connect SMA cable to tranmitter (via "RF IN:).
3. Connect Power adapter(120VAC / 12VDC 500mA) to DC JACK
RF Singnal from
QUICK INSTALL GUIDE
Model: APW-1000
Model: APW-1000
+
Transmitter
RF Singnal
to Antenna
RF IN
RF OUT
5.8GHz Outdoor RF Power Amplifier
DC IN
1. PACKAGE CONTENTS：
DC JACK
Make sure that all units shown as below are enclosed,
please contact your dealer if anything is missing.
1
4. SPECIFICATION :
2
Operating frequency range
P1dB
5.0---6.0 GHz
26 dBm
Power gain
Match impedance
Input VSWR
18 dB typical
50 Ohm
2:1
1. -- APW-1000 Outdoor RF Amplifier *1
2. -- Waterproof Power Cable( 2 m) *1
3. -- Cable (SMA male, 25") *1
Supply voltage
Supply current
Dimension
Operating temperature
Storage temperature
Waterproof Rate
+12 ~ +28 VDC
< 380 mA
125 mm * 80 mm * 40 mm
-20 to +65 Ԩ
-40 to +85 Ԩ
IP 65
4. -- Power adapter (input: 120V DC, 60Hz, 9.7W output: 12V DC, 500mA) *1
2. FUNCTION
1 -- SMA FEMALE ;RF Signal Input
2 -- DC power input ,connect to power supply (12V~28V)
3 -- SMA FEMALE ;RF Signal Output
NOTE:
1. Keep the coaxial cable between the APW-1000 and Transmitter as short as possible.
1
2. Keep the coaxial cable between the APW-1000 and Antenna as short as possible.
3. Make certain all connections are tight.
3
Model:APW-1000
RF IN
RF OUT
4. Make certain all screws has locked on the cover.
DC IN
2
|